<2. Basic Design and Function Design>
2.1.2 Checking Operation Specifications of I/O Modules
Compare the operation specification of each I/O module against the requirement
specification to ensure that requirements can be met.
For more details, see Section 8.1, "Checking Operation Specifications of I/O
Modules;" Section 8.2, "Checking Serial Communication Specification" of Chapter
8, "Detailed Description," as well as the "STARDOM FCN/FCJ Guide."
2.1.3 Checking Automatic Loading of I/O Modules
Operation settings, device label names and all other configuration information of
I/O modules and communication modules are saved in the on-board flash
memory of the FCN-500 and FCN-RTU. Using Resource Configurator, whether to
automatically load configuration information into a new I/O module when an I/O
module is replaced can be specified.
If automatic loading is enabled, configuration information stored on the flash
memory is loaded and a replacement I/O module begins operations
automatically provided if the same model name I/O module being replaced.
Otherwise, confirmation information is not loaded automatically.
If automatic loading is disabled, configuration information stored on the flash
memory is not loaded automatically regardless of the model of the
replacement module.
In such case, redefine and download settings using the Resource Configurator
and rebooting the FCN-500 or FCN-RTU is required.
To Next Page
Loading...
Need help?
General
