YOKOGAWA STARDOM FCN-RTU - 5.6 Logic Designers Debug Mode

<5. Function Test>
95
TI 34P02K35-02E
Jun. 6, 2018-00
5.6 Logic Designer’s Debug Mode
Before checking the operation of a control application using Logic Designer, switch
Logic Designer to Debug mode.
This section describes the know-how and precautions when debugging a control
application using Logic Designer.
SEE ALSO
For details on how to perform debugging in Logic Designer, see Section 4.8, "Hands on: Checking
Operation” of TI “STARDOM FCN/FCJ Primer – Fundamental.”