<4. Control Application Creation>
4. Control Application Creation
Control applications executed by FCN-500 and FCN-RTU autonomous
controllers are created using Logic Designer and then downloaded to the
FCN-500 and FCN-RTU.
This chapter describes precautions on Logic Designer setup, as well as basic
principle, know-how and prohibitions on creating control applications.
For details on basic user operations of Logic Designer, see TI “STARDOM FCN-
500/FCN-RTU Primer – Fundamental" and the Logic Designer online help
documentation.
4.1 Using Logic Designer Setup
This section describes the required setup and selection using Logic Designer
before creating a control application, along with related precautions and
know-how information.
4.1.1 Selecting a Template for a New Project
When creating a new project using Logic Designer, select a project type from a list
of template projects.
For details on how to create a new project and select a template, see Section 4.1.2,
“Creating a New Project” of TI “STARDOM FCN-500FCN-RTU Primer –
Fundamental.”
● Template Types and Selection Criteria
When creating a new project, the project type can be selected from the following
three template projects.
• STARDOM FCX
This is the minimal template, which provides only system-defined functions and
function blocks. It does not include NPAS_POU, PAS_POU, serial
communication function blocks and function blocks for Foundation Fieldbus.
As such, select this template only when creating an application that uses neither
NPAS_POU nor PAS_POU.
• STARDOM FCN-500
It is the standard template for creating control application for the FCN-500.
Necessary functions for creating the control application has been prepared in
advance. (NPAS_POU, serial communication function block, function block for
Foundation Fieldbus, Turbomashinary, etc.)
If necessary, it is possible to add other library after creating a project.
To Next Page
Loading...
Need help?
General
