<4. Control Application Creation>
• STARDOM FCX_A
It is the standard template for creating control application for the FCN-RTU.
Necessary functions for creating the control application has been prepared in
advance. (NPAS_POU, serial communication function block, function block for
Foundation Fieldbus, Turbomashinary, etc.)
If necessary, it is possible to add other library after creating a project.
● Adding Libraries
Logic Designer allows libraries to be added to a project to expand the available
functions.
Similarly, an application using an APPF can be created by installing the required
APPF from DVD-ROM to a PC running Logic Designer, and adding the relevant
libraries to the project.
Examples:
- To create an application using NPAS POUs, select the STARDOM FCX template
when creating the project, and then add the related NPAS_POU library.
Which library to add depends on the function to be aded. For details on the type of
library to be added and the procedure, see the online help documentation of each
function.
● Logic Designer Libraries and FCN-500, FCN-RTU Licenses
No license is required for adding a library to Logic Designer. In other words,
application development using a system function is allowed even if no license for
that function is registered in the FCN-500 or FCN-RTU.
However, a PLC error will be generated and the FCN-500 or FCN-RTU cannot run if
a project is downloaded to an FCN-500 or FCN-RTU without registering with the
required licenses for all functions used in the project.
When adding a library for functionality expansion, check that the required license is
registered in the FCN-500 or FCN-RTU .
SEE ALSO
Section 2.1.5, "Required Licenses”
To Next Page
Loading...
Need help?
General
