YOKOGAWA STARDOM FCN-RTU - 3. Hardware Setup; 3.1 Resource Configurator Setting

<3. Hardware Setup>
25
TI 34P02K35-02E
Jun. 6, 2018-00
3. Hardware Setup
After reviewing and deciding on a desired FCN-500 and FCN-RTU hardware
configuration as described in Chapter 2, perform the actual FCN-500 and FCN-
RTU hardware setup by running Resource Configurator and by accessing the
FCN/FCJ maintenance homepage using a generic web browser.
3.1 Resource Configurator Setting
Among the hardware configuration items reviewed and described in Chapter 2, the
following items are configured using Resource Configurator:
- I/O module operation
- Enabling/disabling of automatic loading of I/O modules
- Duplexed operation
- Enabling/disabling of hardware backup of retain data
SEE ALSO
- Section 2.1.2,”Checking Operation Specifications of I/O Modules”
- Section 2.1.3,”Checking Automatic Loading of I/O Modules”
- Section 2.1.4,”Measures for Duplexing”
- Section 2.2.5,”Retentive Variable (Retain Data) Considerations”
IMPORTANT
Do not turn off the power to the FCN-500 and FCN-RTU controller while
downloading Resource Configuration.
It will take up to three minutes to complete the download operation.
For details on the Resource Configurator and how to use the Resource Configurator
Editor, read “STARDOM FCN-500/FCN-RTU Primer – Fundamental”（TI 34P02K13-
02） and the Resource Configurator online help documentation.