YOKOGAWA STARDOM FCN-RTU User Manual

v
TI 34P02K35-02E Jun. 6, 2018-00
5.6 Logic Designer’s Debug Mode ................................................................ 95
5.6.1 Switching to Debug Mode ............................................................. 96
5.6.2 Basic Operation in Debug Mode ................................................... 99
5.6.3 Disconnecting I/O .......................................................................... 99
5.6.4 Entering and Checking Values of Device Label Variables .......... 101
5.7 Software Wiring ...................................................................................... 106
5.7.1 Overview of Software Wiring ....................................................... 106
5.7.2 Software Wiring Creation and Precautions ................................. 107
5.7.3 Precautions When Creating Software Wiring ............................. 109
5.8 Using Loop Check Tool ........................................................................... 110
5.8.1 Values Displayed in Loop Check Tool .......................................... 111
5.8.2 Locating Problems Using Loop Check Tool ................................. 112
6. User Acceptance Test (UAT) ........................................................ 114
6.1 Pre-UAT Checklist ................................................................................... 114
6.1.1 UAT Prerequisites ........................................................................ 114
6.1.2 UAT Implementation Guidelines................................................... 115
6.2 Items Requiring Prior Explanation to Users ......................................... 116
6.2.1 Differences in Equipment Used from Actual System ................... 116
6.2.2 Differences between Process I/O and Software Wiring ............... 117
6.2.3 Equipment Communicating with FCN-500, FCN-RTU ................. 117
7. System Delivery Precautions ...................................................... 118
7.1 System Delivery Checklist ...................................................................... 119
7.1.1 System Delivery Prerequisites ..................................................... 119
7.1.2 Forms of Delivery ......................................................................... 119
7.2 Delivery for New System ....................................................................... 121
7.2.1 Pre-Delivery Preparation ............................................................. 121
7.2.2 Control Application Backup ......................................................... 122
7.2.3 System Delivery .......................................................................... 123
7.3 Delivery for System Expansion ............................................................. 124
7.4 Delivery for System Modification .......................................................... 125
7.4.1 Pre-Delivery Preparation and Application Backup ...................... 125
7.4.2 System Delivery .......................................................................... 125
7.4.3 Preparation for On-site Installation ............................................. 125
7.4.4 On-site Installation ...................................................................... 126
7.5 Procedure Instruction Sheet and Rehearsal ....................................... 127
8. Detailed Description ..................................................................... 128
8.1 Checking Operation Specifications of I/O Modules ............................ 128
8.1.1 Checking Operation Specification of Analog/Digital Input .......... 128
8.1.2 Checking Operation Specification of Analog/Digital Output ........ 130
8.1.3 Checking Specification of Pulse Input......................................... 132
8.1.4 Checking Specification of Pulse Width Output ........................... 133
8.2 Checking Specification of Serial Communication .............................. 135

YOKOGAWA STARDOM FCN-RTU Specifications

General

Brand	YOKOGAWA
Model	STARDOM FCN-RTU
Category	Controller
Language	English