EasyManuals Logo

YOKOGAWA WT3002E User Manual

YOKOGAWA WT3002E
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
7-22
IM WT3001E-51EN
7.5 Selecting the PLL Source
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
MENU
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY
ITEM & ELEMENT
RESET SET
PAGE PAGE
SCALING
HRM SET
MEASURE
SYNC SOURCE
AVG
LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE
IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
Cursor keys
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase “press the cursor
keys” may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User’s Manual,
IM WT3001E-01EN.
1.
Press HRM SET to display the Harmonics menu.
2.
Press the PLL Source Up Exec or the PLL Source Down Exec soft key to select
the PLL source. The selected PLL source is displayed in the upper right corner of
the screen at PLL Source.
Press the PLL Source Down Exec soft key to switch the selected PLL source as follows:
U1 –> I1 –> U2–>I2 and so on.
Press the PLL Source Up Exec soft key to switch the selected PLL source as follows:
I2 –> U2 –> I1 –> U1 and so on.
Normal measurement
mode
Wide bandwidth
harmonic measurement
mode
IEC harmonic
measurement mode

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YOKOGAWA WT3002E and is the answer not in the manual?

YOKOGAWA WT3002E Specifications

General IconGeneral
BrandYOKOGAWA
ModelWT3002E
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals