YOKOGAWA WT3002E - Setting of the Time Difference from GMT or SNTP

5-23
IM WT3001E-51EN
Ethernet Communications (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
5.7 Setting of the Time Difference from GMT or
SNTP
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
MENU
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY ITEM & ELEMENT
RESET SET
PAGE PAGE
SCALING
HRM SET MEASURE SYNC SOURCE
AVG LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
Cursor keys
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase “press the cursor
keys” may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User’s Manual,
IM WT3001E-01EN.
1.
Press MISC to display the Misc menu.
2.
Press the Next 1/2 soft key to display the Next 2/2 menu.
3.
Press the Network soft key to display the Network menu.
4.
Press the Others soft key to display the Others dialog box.
• Setting the Time Difference from GMT (Greenwich Mean Time)
5.
Press the cursor keys to select Time Hour under Time Difference from GMT.
6.
Press SET to display the entry box.
7.
Press the cursor keys to set the hour in the range of –12 to 13.
8.
Press SET to confirm.
9.
Likewise, set the minute in the range of 0 to 59.
Note
Minute can be specified only if Time Hour is set in the range of –11 to 12. (Minute cannot be
specified if Time Hour is set to –12 or 13.)