YOKOGAWA WT3002E - Chapter 4 RGB Video Signal (VGA) Output (Option); Names and Functions of the Parts of the RGB Video Signal (VGA) Output

4-1
IM WT3001E-51EN
RGB Video Signal (VGA) Output (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
4.1 Names and Functions of the Parts of the RGB
Video Signal (VGA) Output
Rear Panel
VIDEO-OUT
(VGA)
RGB video signal (VGA) output
connector
Outputs image signals.
The screen of this instrument can be output to a monitor through the RGB video signal
(VGA) output. Connectable monitors are VGA monitors or multi-sync monitors capable of
displaying VGA.
CAUTION
• Connect the cable after turning OFF this instrument and the monitor.
• Do not short the RGB VIDEO OUT terminal or apply external voltage to it. If you
do, the instrument may malfunction.
French
ATTENTION
• Connecter le câble après avoir mis cet instrument et le moniteur hors tension.
• Ne pas court-circuiter la borne RGB VIDEO OUT ni y appliquer de tension
externe. Le cas échéant, un dysfonctionnement de l’instrument est possible.
Pin Arrangement and Assignments of the Video Signal Output Connector
The pin arrangement and assignments of the connector are as follows:
Pin No. Signal Name Specifications
1 Red 0.7 Vp-p
2 Green 0.7 Vp-p
3 Blue 0.7 Vp-p
4 –
5 –
6 GND
7 GND
8 GND
9 –
10 GND
11 –
12 –
13 Horizontal sync signal Approx. 31.5 kHz, TTL (negative logic)
14 Vertical sync signal Approx. 60 Hz, TTL (negative logic)
15 –
Chapter 4 RGB Video Signal (VGA) Output (Option)
VIDEO-OUT
(VGA)
1
5
6
10
11
15