3-10
IM WT3001E-51EN
3.3 Setting the D/A Zoom
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
LOWER ITEM LOWER FORM ALL USER SET
RESET SET
PAGE PAGE
SCALING
HRM SET
MEASURE
SYNC SOURCE
AVG
LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE
IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
Cursor keys
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase “press the cursor
keys” may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User’s Manual,
IM WT3001E-01EN.
1.
Press MISC to display the Misc menu.
2.
Press the Next 1/2 soft key to display the Next 2/2 menu.
3.
Press the D/A Output Items soft key to display the D/A Output menu.
• Selecting the Target Channel
4.
Press the cursor keys to select a value between 1 and 20.
• Selecting Whether to D/A Zoom (Manual Range Mode or Fixed Range Mode)
5.
Press the Range Mode soft key to select Manual or Fixed. If Manual is selected,
proceed to step 6.
• Setting the Maximum Value of the D/A Output Range for Manual Range
Mode
6.
Press the Rated Max soft key.
7.
Press the cursor keys to set the maximum value.
• Setting the Minimum Value of the D/A Output Range for Manual Range Mode
8.
Press the Rated Min soft key.
9.
Press the cursor keys to set the minimum value.
To Next Page
Loading...
