YOKOGAWA WT3002E - Chapter 5 Ethernet Communications (Option); Connecting to the Network

5-1
IM WT3001E-51EN
Ethernet Communications (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
5.1 Connecting to the Network
When Connecting to a PC on the Network
1.
Turn OFF the power switch of this instrument(see section 3.4 in the User’s Manual
IM WT3001E-01EN).
2.
Connect one end of the UTP (or STP) cable to the ETHERNET 100BASE-TX
terminal on the rear panel.
3.
Connect the other end of the UTP (or STP) cable to a hub or router.
4.
Turn ON the power switch of this instrument.
Hub or router that supports 100BASE-TX
UTP cable
or
STP cable
(Straight)
100BASE-TX port
RJ-45 modular jack
Ethernet NIC
PC
100
BASE-
TX
ETHERNET
Connecting to the PC in a One-to-One Configuration
1.
Turn OFF the power switch of this instrument(See section 3.4 in the User’s
Manual IM WT3001E-01EN).
2.
Connect one end of the UTP (or STP) cable to the ETHERNET 100BASE-TX
terminal on the rear panel.
3.
Connect the other end of the UTP (or STP) cable to a hub or router.
4.
Likewise, connect the PC to a hub or router.
5.
Turn ON the power switch of this instrument(see section 3.4 in the User’s Manual
IM WT3001E-01EN).
Hub or router that supports 100BASE-TX
UTP cable
or
STP cable
(Straight)
Ethernet NIC
PC
Note
• When connecting this instrument and a PC in a one-to-one configuration, use a 10BASE-
T/100BASE-TX auto switching NIC or a 100BASE-TX NIC on the PC side.
• Use UTP (Unshielded Twisted-Pair) or STP (Shielded Twisted-Pair) cables of straight type
and category 5 or better.
• Do not connect this instrument and a PC directly without going through a hub. Operations
are not guaranteed for communications using direct connection.
Chapter 5 Ethernet Communications (Option)