7-28
IM WT3001E-51EN
7.8 Setting the Anti-Aliasing Filter
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
LOWER ITEM LOWER FORM ALL USER SET
RESET SET
PAGE PAGE
SCALING
HRM SET
MEASURE
SYNC SOURCE
AVG
LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE
IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
Cursor keys
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase “press the cursor
keys” may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User’s Manual,
IM WT3001E-01EN.
When making harmonic measurements, the line filter of normal measurement mode is
used as an anti-aliasing filter.
• Selecting the Line Filter
1.
Press LINE FILTER to display the Line Filter menu.
Only the installed elements are displayed.
• Selecting the Target Element
2.
Press one of the soft keys corresponding to the displayed element to select the
target element.
• Selecting the Line Filter
3.
Press the cursor keys to select any filter between OFF and 50 kHz. If any of
the target elements is set to a setting other than OFF, the LINE FILTER key
illuminates.
To Next Page
Loading...
