YOKOGAWA WT3002E - Setting the Waveform Equation

10-5
IM WT3001E-51EN
Waveform Computation (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
10.4 Setting the Waveform Equation
Procedure
START STOP
REMOTE
CAL
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGE VOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY ITEM & ELEMENT
2
3 4
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE AUTO
EXT SENSOR
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
RESET SET
PAGE PAGE
Cursor keys
To exit the menu during
operation, press ESC located
above the soft keys.
In the procedural explanation
below, the phrase “press the
cursor keys” may be used.
This phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the
User’s
Manual, IM WT3001E-01EN.
1.
Press ITEM to display the Wave/Math Items menu.
If the waveform computation display is at the lower section of the screen on the split
display, press SHIFT+ITEM (LOWER ITEM).
2.
Press the Math Setup soft key to display the Math Setup dialog box.