YOKOGAWA WT3002E - Setting the Delta Computation

6-2
IM WT3001E-51EN
6.2 Setting the Delta Computation
Procedure
START STOP
REMOTE
CAL
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGE VOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY ITEM & ELEMENT
2
3 4
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE AUTO
EXT SENSOR
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
RESET SET
PAGE PAGE
Cursor keys
To exit the menu during
operation, press ESC located
above the soft keys.
In the procedural explanation
below, the phrase “press the
cursor keys” may be used.
This phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the
User’s
Manual, IM WT3001E-01EN.
1.
Press WIRING to display the Wiring menu.
2.
Press the ∆Measuresoftkeytodisplaythe∆Measuredialogbox.
• Selecting the Target Wiring Unit for the Delta Computation
3.
Press the cursor keys to select the wiring unit.
(This step may not be necessary depending on the wiring system.)
4.
Press SET to confirm. A type selection box appears.
• Selecting the Delta Computation Type
5.
Press the cursor keys to select the delta computation type.
(The menu varies depending on the wiring system.)
6.
Press SET to confirm.