YOKOGAWA WT3002E - Displaying Vectors

7-35
IM WT3001E-51EN
Harmonic Measurement in Normal Measurement Mode (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
7.10 Displaying Vectors
Procedure
START STOP
REMOTE
CAL
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGE VOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY ITEM & ELEMENT
2
3 4
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE AUTO
EXT SENSOR
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
RESET SET
PAGE PAGE
Cursor keys
To exit the menu during
operation, press ESC located
above the soft keys.
In the procedural explanation
below, the phrase “press the
cursor keys” may be used.
This phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the
User’s
Manual, IM WT3001E-01EN.
• Displaying Vectors
1.
Press OTHERS to display the Others menu.
2.
Press the Vector soft key to select the display mode.
• Selecting the Wiring Unit to Be Displayed
3.
Press FORM to display the Vector Form menu.
4.
Press the Object soft key to display the Object menu.
5.
Press the ΣA or ΣB soft key to select the wiring unit to be displayed.
• Turning ON/OFF the Numeric Data Display
Press the Numeric soft key to select ON or OFF.