11-16
IM WT3001E-51EN
11.8 Displaying the Power Spectrum on the Split
Screen
Procedure
START STOP
REMOTE
CAL
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGE VOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY
ITEM & ELEMENT
2
3 4
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE
AUTO
EXT SENSOR
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
RESET SET
PAGE PAGE
Cursor keys
To exit the menu during
operation, press ESC located
above the soft keys.
In the procedural explanation
below, the phrase “press the
cursor keys” may be used.
This phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the
Manual, IM WT3001E-01EN.
1.
Press FORM to display the FFT Form menu.
If the FFT display is at the lower section of the screen on the split display, press
SHIFT+FORM (LOWER FORM).
2.
Press the Format soft key to display the FFT Format menu.
3.
Press one of the keys from Single or Dual to select the number of windows.
Explanation
The screen can be evenly divided and the waveforms can be assigned to the divided
windows. Select the number of divisions of the screen from the choices below.
• Single: 1 window
• Dual: 2 equally divided windows
The number of displayed points in the vertical direction of one divided window varies
depending on the number of divisions as follows:
• Single: 432 points
• Dual: 216 points
To Next Page
Loading...
