11-12
IM WT3001E-51EN
11.6 Setting the Display Range of the X-Axis
(Frequency) and the Scale Type of the Y-Axis
(Signal Amplitude)
Procedure
START STOP
REMOTE
CAL
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGE VOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY
ITEM & ELEMENT
2
3 4
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE
AUTO
EXT SENSOR
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
RESET SET
PAGE PAGE
Cursor keys
To exit the menu during
operation, press ESC located
above the soft keys.
In the procedural explanation
below, the phrase “press the
cursor keys” may be used.
This phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User’s
Manual, IM WT3001E-01EN.
1.
Press FORM to display the FFT Form menu.
If the FFT display is at the lower section of the screen on the split display, press
SHIFT+FORM (LOWER FORM).
• Setting the Display Range of the X-Axis (Frequency)
2.
Press the Disp Start/Disp End soft key to select Disp Start, Disp end, or both
Disp Start and Disp End.
• If you select Disp Start, you can set the left end of the power spectrum display (minimum
value of the computed points).
• If you select Disp End, you can set the right end of the power spectrum display (maximum
value of the computed points).
• If you select both Disp Start and Disp End, you can set the computed points of the power
spectrum display without changing the offset between the computed points of Disp Start
and Disp End. The cursor is displayed at Disp Start.
3.
Press the cursor keys to set the computed point.
To Next Page
Loading...
