YOKOGAWA WT3002E - Setting the Pulse Range, Pulse Count, and Pulse Rating

1-12
IM WT3001E-51EN
1.6 Setting the Pulse Range, Pulse Count, and
Pulse Rating
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
MENU
LOWER ITEM LOWER FORM ALL USER SET
DISPLAY ITEM & ELEMENT
RESET SET
PAGE PAGE
SCALING
HRM SET MEASURE SYNC SOURCE
AVG LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase “press the cursor
keys” may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User’s Manual,
IM WT3001E-01EN.
Cursor keys
The settings covered in this section apply to the case when the input signal type is set to
Analog. You do not have to specify the settings in this section if the input signal type is
set to Pulse.
1.
Press SHIFT+SCALING (MOTOR SET) to display the Motor Set dialog box.
• Setting the Pulse Input Range of the Revolution Signal
If the revolution signal type is Pulse, set the upper and lower limits of the pulse input
range.
2.
Press the cursor keys to select Pulse Range Upper under Speed.
3.
Press SET. A pulse input range setup box appears.
4.
Press the cursor keys to set the upper limit of the pulse input range.
5.
Press SET or ESC to close the box.
6.
Press the cursor keys to select Pulse Range Lower under Speed.
7.
Press SET. A pulse input range setup box appears.
8.
Press the cursor keys to set the lower limit of the pulse input range.
9.
Press SET or ESC to close the box.