8-2
IM WT3001E-51EN
8.2 Various Settings Related to Wide Bandwidth
Harmonic Measurement
Most of the operations of wide bandwidth harmonic measurement mode are common
with the harmonic measurement of normal measurement mode. A setting specific to the
wide bandwidth harmonic measurement is the ON/OFF setting of the timeout warning
display of the PLL lock. For these settings, see the respective sections below. The
underlined sections are settings specific to the wide bandwidth harmonic measurement.
• Selecting the wide bandwidth harmonic measurement mode Section 8.3
• Changing the number of displayed items of numeric data and Section 7.3
scrolling the display
• Changing the displayed items of numeric data Section 7.4
• Selecting the PLL Source Section 7.5
• Setting the measured order Section 7.6
• Selecting the distortion factor equation Section 7.7
• Turning ON/OFF the timeout warning display of the PLL lock Section 8.4
• Setting the anti-aliasing filter Section 7.8
• Displaying the bar graph and making cursor measurements Section 7.9
• Displaying vectors Section 7.10
To Next Page
Loading...
