YOKOGAWA WT3002E - Page 178

10-10
IM WT3001E-51EN
• Setting the Scaling of the Computed Waveform
• Selecting Auto or Manual Scaling
3.
Press the cursor keys to select Scale of Math1 or Math2.
4.
Press SET to display the scaling selection box.
5.
Press the cursor keys to select Auto or Manual.
6.
Press the SET key to confirm.
If you selected Auto, proceed to step 15 on the next page.
If you selected Manual, proceed to step 7.
Display example when Scale of Math1 is selected
• Setting the Center Value of Manual Scaling
7.
Press the cursor keys to select Center of Math1 or Math2.
8.
Press SET to display the center value setup box.
9.
Press the cursor keys to set the center value.
10.
Press the SET key to confirm the center value.
• Setting the Scale/Division Setting (Vertical Zoom Factor) of Manual Scaling
11.
Press the cursor keys to select Scale/div of Math1 or Math2.
12.
Press SET to display the Scale/div setup box.
13.
Press the cursor keys to set the scale/division value.
14.
Press the SET to confirm the scale/division value.
Display example when Center of Math1 is selected Display example when Scale/div of Math1 is selected
10.5 Setting the Scale, Unit, and Label of the Computed Waveform