YOKOGAWA WT3002E - Page 72

5-3
IM WT3001E-51EN
Ethernet Communications (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
When Using Only DHCP
5.
Press the cursor keys to select DHCP.
6.
Press SET to select ON.
7.
Press the cursor keys to select DNS.
8.
Press SET. A DNS selection box appears.
9.
Press the cursor keys to select OFF.
When Using Only DNS
5.
Press the cursor keys to select DHCP.
6.
Press SET to select OFF.
• Entering the IP Address
7.
Press the cursor keys to select IP Address.
8.
Press SET. An IP address entry box appears.
9.
Press the cursor keys to enter the IP address of this instrument.
10.
Press SET or ESC to close the box.
11.
Enter all four octets of the IP address.
• Entering the Subnet Mask
Enter the subnet mask according to the system or network to which this instrument
belongs. If the subnet mask is not required, proceed to “Entering the Default Gateway.”
12.
Press the cursor keys to select Net Mask.
13.
Enter all four octets of the subnet mask of the network to which this instrument
belongs in the same fashion as the IP address.
• Entering the Default Gateway
Enter the default gateway according to the system or network to which this instrument
belongs. If the default gateway is not required, proceed to “Turning ON the DNS.”
14.
Press the cursor keys to select Gate Way.
15.
Enter all four octets of the default gateway of the network to which this instrument
belongs in the same fashion as the IP address.
5.2 Setting TCP/IP