5-15
IM WT3001E-51EN
Ethernet Communications (Option)
Explanation
The LPR client function of this instrument can be used to output screen images to a
network printer.
• Printer Server
• Specify the printer server by entering the IP address.
• If you are using DNS (see section 5.2), you can specify the server by name.
• Printer Name
Enter the name of the output destination printer on the network.
• Selecting the Output Command
Select the output command type from the choices below.
• BJ
• PCL5
• LIPS3
• Turning ON/OFF Color Printing
You can select whether to output the image in color when the output command type is
BJ, or PCL5.
• ON
The displayed screen image can be output to a printer in color (256 colors).
• OFF
The displayed screen image can be output to a printer in black and white.
• Setting Comments
Same as the explanation given in “File Name and Comment” in section 9.3 in the
User’s Manual IM WT3001E-01EN.
Note
• The LPR client function cannot be used under the following cases.
• When this instrument is performing file operations (see chapter 9 in the User’s Manual
IM WT3001E-01EN).
• When this instrument is being accessed by a PC or workstation on the network (FTP
server function, see section 5.6).
• To use the LPR client function, you must configure TCP/IP (see section 5.2) in advance.
• Output is possible to printers that support the TCP/IP protocol.
5
5.4 Printing Screen Images on a Network Printer
To Next Page
Loading...
