Getting Started
10
Preparing the L10 Tablet for First Use
This section has steps for setting up the L10 platform for the first use.
Inserting a SIM Card
If your L10 tablet is enabled with Wireless Wide Area Networking (WWAN), you need an activated SIM card in the
SIM card holder to access the cellular data network. The SIM holder is located in the battery bay of the L10 and
can hold one or two Nano SIMs (4FF).
The L10 supports two SIM cards and switching between SIMs is done within Windows. Most people will need only
one SIM. To add or change a SIM, follow these instructions:
1. Shut down and turn off the tablet.
2. Remove the battery if it is in the tablet.
3. Pull out the SIM holder shown above.
4. Put your SIM card into the slot with the contacts facing down ensuring the notched edge on the card aligns with
the notched edge in the holder.
5. Then put the frame back into its port and return the battery to its bay.
Powering Up the Tablet
1. Remove the battery from the packaging. On the back of the tablet, insert the bottom of the battery into the bay.
Tilt the battery as shown and press it down until it clicks securely into place.
Docking
connectors
SIM card holder
Insert this end of the
battery first.
To Next Page
Loading...
Need help?
General
