5 - 4 TC56 User Guide for Android Version 6.0.1
2. Point the exit window on the top of the TC56 at a bar code.
Figure 5-4 Imager Scanning
3. Press and hold the scan button.
The red laser aiming pattern turns on to assist in aiming.
4. Ensure the bar code is within the area formed by the aiming pattern. The aiming dot is used for increased
visibility in bright lighting conditions.
Figure 5-5 Aiming Pattern
Figure 5-6 Pick List Mode with Multiple Bar Codes in Aiming Pattern
NOTE When the TC56 is in Picklist mode, the imager does not decode the bar code until the crosshair or aiming
dot touches the bar code.
To Next Page
Loading...
