Getting Started 1 - 13
10. Replace the hand strap, if required.
11. Press the Power button to turn on the TC56.
Replacing the microSD Card
To replace the microSD card:
1. Press the Power button until the menu appears.
2. Touch Power off.
3. Touch OK.
4. If hand strap is attached, slide the hand strap clip up toward the top of the TC56 and then lift.
5. Press the two battery latches in.
6. Lift the battery from the TC56.
7. Lift the access door.
Figure 1-20 Remove Access Door
8. Slide the microSD card holder to the Open position.
9. Lift the microSD card holder.
10. Remove microSD card from holder.
11. Insert the replacement microSD card into the card holder door ensuring that the card slides into the holding
tabs on each side of the door.
12. Close the microSD card holder door.
To Next Page
Loading...
