149
2. Ensure that NFC is enabled on the device.
3. Align the NFC icon on the RS6000 with the NFC icon on the device battery.
The Status LED blinks blue indicating that the RS6000 is attempting to establish connection with the
device. When connection is established, the Status LED turns off and the RS6000 emits a single string of
low/high beeps.
A notification appears on the device screen.
The icon appears in the Status bar.
Figure 125 Align NFC Antennas
The device pairs with the RS6000 and appears in the Status bar.
NOTE: Not all Zebra device support NFC readers and the Tap-to-Pair feature.
Pairing in HID Mode Using Near Field Communication
The device provides the ability to pair the RS6000 in HID Mode using NFC.
NOTE: RS6000 only.
1. Ensure that NFC is enabled on the device.
2. Ensure that Bluetooth is enabled on both devices.
3. Ensure that the Bluetooth device to discover is in discoverable mode.
4. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
5. Place the RS6000 in Human Interface Device (HID) mode. If the RS6000 is already in HID mode, skip to
step 6.
a. Remove the battery from the RS6000.
b. Press and hold the Restore key.
c. Install the battery onto the RS6000.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
