150
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
e. Scan the bar code below to place the RS6000 in HID mode.
Figure 126 Bluetooth HID Bar Code
6. Remove the battery from the RS6000.
7. Re-install the battery into the RS6000.
8. Align the NFC icon on the RS6000 with the NFC icon on the device.
The Status LED blinks blue indicating that the RS6000 is attempting to establish connection with the
device. When connection is established, the Status LED turns off and the RS6000 emits a single string of
low/high beeps.
A notification appears on the device screen.
The icon appears in the Status bar.
Figure 127 Align NFC Antennas
The device pairs with the RS6000 and appears in the Status bar.
NOTE: RS6000 only.
Pairing Using Simple Serial Interface
To pair the RS507/RS6000 with the device using SSI:
1. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
2. Install the battery into the RS507/RS6000.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
