Install the Printer Driver and Connect to a Computer
157
4.
Turn on (I) the printer.
The printer boots up.
5. Connect the printer to an Ethernet cable that is connected to your network.
The printer attempts to communicate with your network. If it is successful, it fills in your LAN’s gateway
and subnet values and gets an IP address. The printer display will alternate between the printer’s
firmware version and its IP address.
6. Tap Menu > Connection > Wired > Wired IP Address. Check the display to see if an IP address was
assigned to the printer. See Connection > Wired > Wired IP Address on page 68.
If the printer’s IP address is... Then...
0.0.0.0
or
000.000.000.000
Continue with Configuring the printer with your LAN
information (if necessary) on page 158.
any other value Continue with Adding a Printer from the Zebra Setup
Utilities Screen on page 158.
To Next Page
Loading...