Install the Printer Driver and Connect to a Computer
158
Configuring the printer with your LAN information (if necessary)
If your printer connected to your network automatically, you do not need to complete this section.
Continue with Adding a Printer from the Zebra Setup Utilities Screen.
7. Connect the printer to your computer using a USB, serial, or optional parallel port as instructed in
Connect a Computer to the Printer’s USB Port on page 146 or Connect a Computer to the Printer’s
Serial or Parallel Port on page 149.
8. Configure the following printer settings. You can change the values through the Zebra Setup Utilities
(click Configure Printer Connectivity on the Zebra Setup Utilities screen) or by the ways listed at the
following links. Contact your network administrator for the proper values for your network.
• Connection > Wired > Wired IP Protocol on page 68 (change the value from ALL to PERMANENT)
• Connection > Wired > Wired IP Address on page 68 (assign a unique IP address to the printer)
• Connection > Wired > Wired Subnet on page 69 (match the subnet value of your LAN)
• Connection > Wired > Wired Gateway on page 69 (match the gateway value of your LAN)
9. After the print server settings have been configured, reset the network to apply the changes. See
Connection > Networks > Reset Network on page 65.
Adding a Printer from the Zebra Setup Utilities Screen
10. If necessary, open the Zebra Setup Utilities program.
The Zebra Setup Utilities screen displays.
Figure 13 Zebra Setup Utilities Screen
To Next Page
Loading...