Printer Setup
24
8.
Close the media door.
9. Set the printer to the appropriate collection method (see Print > Label Position > Collection Method on
page 77).
10. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
11. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors on page 89.
12. If desired, print a configuration or other label to verify that your printer is able to print. (See System >
Settings > Print: System Settings on page 64.)
Media loading in Tear-Off mode is complete.
To Next Page
Loading...