Zebra ZT411 - Page 72

Printer Configuration and Adjustment
72
Connection > WLAN > WLAN Security
Select the security type being used on your WLAN.
Related ZPL command(s):
^WX
SGD command used:
wlan.security
Printer web page: View and Modify Printer Settings > Network Communications
Setup > Wireless Encryption Setup
Connection > WLAN > WLAN Band
Set a preferred band to connect with via wifi.
Accepted values: 2.4, 5, None
SGD command used:
wlan.band_preference
Printer web page: View and Modify Printer Settings > Network Communications
Setup > Wireless Setup
Connection > WLAN > WLAN Country Code
The country code defines the regulatory country for which the wireless radio is currently
configured.
IMPORTANT: The list of country codes is specific to each printer and depends on the
printer model and its wireless radio configuration. The list is subject to change,
addition, or deletion with any firmware update, at any time, without notice.
To determine the country codes available on your printer, issue the
! U1 getvar "wlan" command to return all commands related to WLAN settings.
Locate the
wlan.country.code command in the results and view the country codes
available for your printer.
SGD command used:
wlan.country_code