199
Routine Maintenance
Cleaning Schedule and Procedures
6/28/17 ZT510 User Guide P1095460-001
Clean the Exterior, the Media Compartment, and the Sensors
Over time, dust, grime, and other debris may build up on the outside and inside of your printer,
particularly in a harsh operating environment.
Printer Exterior
You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a
mild detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
Media Compartment and Sensors
To clean the sensors, complete these steps:
1. Brush, air blow, or vacuum any accumulated paper lint and dust away from the media and
ribbon paths and the sensors.
Important • Zebra is not responsible for damage caused by the use of cleaning fluids on this
printer.
1
Take-label sensor
2
Snap plate
To Next Page
Loading...