213
Routine Maintenance
Replacing Printer Components
6/28/17 ZT510 User Guide P1095460-001
Replacing Printer Components
Some printer components, such as the printhead and platen roller, may wear out over time and
can be replaced easily. Regular cleaning may extend the life of some of these components. See
Table 5 on page 198 for the recommended cleaning intervals.
Ordering Replacement Parts
For optimal printing quality and proper printer performance across our product line, Zebra
strongly recommends the use of genuine Zebra™ supplies as part of the total solution.
Specifically, the ZT500 Series printers are designed to work only with genuine Zebra™
printheads, thus maximizing safety and print quality.
Contact your authorized Zebra reseller for part ordering information.
Recycling Printer Components
Lubrication
The only lubrication needed for this printer is for the cutter module. Follow the instructions in
Clean and Lubricate the Cutter Module on page 204. Do not lubricate any other parts of the
printer.
The majority of this printer’s components are recyclable. The printer’s main logic board may
include a battery that you should dispose of properly.
Do not dispose of any printer components in unsorted municipal waste. Please dispose of the
battery according to your local regulations, and recycle the other printer components
according to your local standards. For more information, see
http://www.zebra.com/environment.
Caution • Some commercially available lubricants will damage the finish and the
mechanical parts if used on this printer.
To Next Page
Loading...