Printer Setup and Operation
Load the Media
32
P1095460-001 ZT510 User Guide 6/28/17
Load the Media
Use the instructions in this section for loading roll or fanfold media in the appropriate print
mode for your needs.
Insert the Media into the Printer
The majority of the illustrations in this section show roll media because the media loading path
is the same for both roll and fanfold media.
To load media, complete these steps:
1. Raise the media door.
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
To Next Page
Loading...