Zebra ZT510 - WLAN IP ADDRESS

Printer Configuration and Adjustment
Adjust Printer Settings
146
P1095460-001 ZT510 User Guide 6/28/17
NETWORK > WLAN IP ADDRESS
View and, if necessary, change the printer’s wireless IP address.
To save changes to this setting, set WLAN IP PROTOCOL on page 149 to
PERMANENT, and
then reset the print server (see RESET NETWORK on page 156). See IP Address Changing
on page 244 for additional information.
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
Accepted values: 000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
ip.addr, wlan.ip.addr
Printer web page: View and Modify Printer Settings > Network Communications Setup >
Wireless Setup