Printer Configuration and Adjustment
Adjust Printer Settings
112
P1095460-001 ZT510 User Guide 6/28/17
SETTINGS > TEAR OFF
If necessary, shift the position of the media over the tear-off bar after printing.
• Lower numbers move the media into the printer by the specified number of dots (the tear
line moves closer to the edge of the label just printed).
• Higher numbers move the media out of the printer (the tear line moves closer to the
leading edge of the next label).
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
LANGUAGE
Accepted values: –120 to 120
Related ZPL command(s): ~TA
SGD command used:
ezpl.tear_off
Printer web page: View and Modify Printer Settings > General Setup > Tear Off
To Next Page