167
Printer Configuration and Adjustment
Adjust Printer Settings
6/28/17 ZT510 User Guide P1095460-001
SENSORS > TAKE LABEL
Set the intensity of the take label LED.
Important • This value is set during sensor calibration. Do not change this setting unless you
are told to do so by Zebra Technical Support or by an authorized service technician.
SENSORS
—
SENSOR TYPE
—
—
PRINT INFORMATION
—
LABEL SENSOR
—
TAKE LABEL
Accepted values: 0 to 255
SGD command used:
ezpl.take_label
Printer web page: View and Modify Printer Settings > Calibration
To Next Page
Loading...