Zebra ZT510 - WIRED GATEWAY

143
Printer Configuration and Adjustment
Adjust Printer Settings
6/28/17 ZT510 User Guide P1095460-001
NETWORK > WIRED GATEWAY
View and, if necessary, change the default wired gateway.
To save changes to this setting, set WIRED IP PROTOCOL on page 144 to
PERMANENT, and
then reset the print server (see RESET NETWORK on page 156). See IP Address Changing
on page 244 for additional information.
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
Accepted values: 000 to 255 for each field
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.gateway
Printer web page: View and Modify Printer Settings > Network Communications Setup >
TCP/IP Settings