Zebra ZT510 - LABEL LENGTH MAX

Printer Configuration and Adjustment
Adjust Printer Settings
118
P1095460-001 ZT510 User Guide 6/28/17
SETTINGS > LABEL LENGTH MAX
Set a maximum label length that is at least 1.0 in. (25.4 mm) greater than the actual label
length plus the interlabel gap. If you set this value too small, the printer assumes that
continuous media is loaded and cannot calibrate.
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
LANGUAGE
Accepted values: 0 to the maximum label length supported by the printer
For example, if the label length is 6.0 inches (152 mm) including the interlabel
gap, set the parameter for at least 7.0 inches (178 mm).
Related ZPL command(s):
^ML
SGD command used:
ezpl.label_length_max
Printer web page: View and Modify Printer Settings > Media Setup > Maximum Length
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Minimum label length value
1
3