Zebra ZT510 - PRINT WIDTH

113
Printer Configuration and Adjustment
Adjust Printer Settings
6/28/17 ZT510 User Guide P1095460-001
SETTINGS > PRINT WIDTH
Specify the width of the labels being used, in dots. The default value is the maximum width for
the printer, based on the printhead’s DPI value.
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
LANGUAGE
Accepted values:
Note • Setting the width too narrow can result in portions of a label
format not being printed on the media. Setting the width too wide
wastes formatting memory and can cause the printer to print off of the
label and onto the platen roller. This setting can affect the horizontal
position of the label format if the image was inverted using the
^POI
ZPL II command.
203 dpi =
0002 to 832
300 dpi = 0002 to 1248
Related ZPL command(s): ^PW
SGD command used:
ezpl.print_width
Printer web page: View and Modify Printer Settings > Media Setup > Print Width