Zebra ZT510 - VISIBILITY AGENT

157
Printer Configuration and Adjustment
Adjust Printer Settings
6/28/17 ZT510 User Guide P1095460-001
NETWORK > VISIBILITY AGENT
When the printer is connected to a wired or wireless network, it will attempt to connect to
Zebra’s Asset Visibility Service via the Cloud-based Zebra Printer Connector using an
encrypted, certificate-authenticated web socket connection. The printer sends Discovery Data
and Settings and Alerts Data. Data printed via any label formats is NOT transmitted.
To opt out of this feature, disable this setting. For more information, see the “Opting Out of the
Asset Visibility Agent” application note at http://www.zebra.com.
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
Accepted values: • ON
• OFF
SGD command used:
weblink.zebra_connector.enable
Printer web page: View and Modify Printer Settings > Network Configuration >
Cloud Connect Settings