Zebra ZT510 - IP ALTERNATE PORT

155
Printer Configuration and Adjustment
Adjust Printer Settings
6/28/17 ZT510 User Guide P1095460-001
NETWORK > IP ALTERNATE PORT
This command sets the port number of the alternate TCP port.
n
Note • Print servers supporting this command will monitor both the primary port and the
alternate port for connections at the same time.
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS
SGD command used: internal_wired.ip.port_alternate
Printer web page: View and Modify Printer Settings > Network Communications Setup >
TCP/IP Settings