Zebra ZT510 - Page 252

Using the USB Host Ports and the NFC Capabilities
USB Host
252
P1095460-001 ZT510 User Guide 6/28/17
6. Observe the control panel and wait.
The following should happen:
• If the firmware on the USB Flash drive is different than what is on the printer, the
firmware downloads to the printer. The printer then restarts and prints a printer
configuration label. (If there is no firmware on the USB Flash drive or if the firmware
version is the same, the printer skips this action.)
• The printer downloads the files in the
/files folder and briefly shows the names of
the files that are downloading on the display.
• The printer executes any files in the
/commands folder.
• The printer restarts and then displays the message
MIRROR PROCESSING FINISHED.
7. Remove the USB Flash drive from the printer.
Advanced User Information
See the Zebra
®
Programming Guide for more information about these commands.
Enable/disable mirroring:
! U1 setvar "usb.mirror.enable" "value"
Values: "on" or "off"
Enable/disable automatic mirroring that occurs when a USB Flash drive is inserted into the
USB host port:
! U1 setvar "usb.mirror.auto" "value"
Values: "on" or "off"
Specify the number of times that the mirror operation will be repeated if it fails:
! U1 setvar "usb.mirror.error_retry" "value"
Values: 0 to 65535
Change the path to the location on the USB device from which mirror files are retrieved:
! U1 setvar "usb.mirror.appl_path" "new_path"
Default: "zebra/appl"
Change the path to the location on the printer from which mirror files are retrieved:
! U1 setvar "usb.mirror.path" "path"
Default: "zebra"
Enable/disable the ability to use the USB port:
! U1 setvar "usb.host.lock_out" "value"
Values: "on" or "off"