Zebra ZT510 - Page 38

Printer Setup and Operation
Load the Media—Tear-Off Mode
38
P1095460-001 ZT510 User Guide 6/28/17
5. Thread the media under the media dancer assembly roller (1), the media guide roller (2),
and then the upper media sensor (
3).
6.
Important • Make sure that you thread the media under these components. If you thread
the media over them, the media obstructs the ribbon sensor and causes a false
RIBBON OUT error.
1
2
3
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Push the media forward until it passes under the printhead assembly (1), under the
snap plate (
2), and then over the platen roller (3).
3
2
1