Printer Setup and Operation
Load the Media—Tear-Off Mode
40
P1095460-001 ZT510 User Guide 6/28/17
10. Rotate the printhead-open lever downward until it locks the printhead in place.
11. Close the media door.
12. Set the printer to the appropriate print mode (see PRINT MODE on page 114).
13. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
14. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 179.
15. If desired, print a configuration or other label to verify that your printer is able to print.
(See PRINT INFORMATION on page 119.)
Media loading in Tear-Off mode is complete.
To Next Page
Loading...