Printer Setup and Operation
Load the Media—Peel-Off Mode or Applicator Mode
44
P1095460-001 ZT510 User Guide 6/28/17
7.
8.
Extend approximately 18 in. (500 mm) of media out of the printer. Remove and discard
the labels from this exposed media, leaving just the liner.
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Push the media forward until it passes under the printhead assembly (1), under the
snap plate (
2), and then over the platen roller (3).
To Next Page
Loading...