Zebra ZT510 - Page 59

59
Printer Setup and Operation
Load the Media—Cutter Mode or Delayed Cut Mode
6/28/17 ZT510 User Guide P1095460-001
5. Thread the media under the media dancer assembly roller (1), the media guide roller (2),
and then the upper media sensor (
3).
6.
Important • Make sure that you thread the media under these components. If you thread
the media over them, the media obstructs the ribbon sensor and causes a false
RIBBON OUT error.
1
2
3
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.
Push the media forward until it passes under the printhead assembly (1), under the
snap plate (
2), and then through the cutter assembly (3).
3
2
1