221
Routine Maintenance
Cleaning Schedule and Procedures
5/22/17 ZT600 Series™ User Guide P1088680-001
8.
Important • This part of the procedure should be performed only by experienced users
and only when the cutter blade is not fully exposed for cleaning, as shown in the previous
step.
8-a. Remove the cutter mounting screw.
8-b. Slide the cutter module to the right to align the cutter assembly tabs (1) and cutter
cover tabs (
2) with the corresponding slots (3) in the printer, and then lift the
cutter module out of the printer. Take care not to damage the wires that connect the
cutter module to the printer. If desired, you may disconnect these wires.
To Next Page
Loading...