Printer Setup and Operation
Load the Media—Peel-Off Mode or Applicator Mode
44
P1088680-001 ZT600 Series™ User Guide 5/22/17
12. Rotate the media guide adjustment knob as shown until the media guide just touches the
edge of the media.
13. Does the media that you are using require ribbon for printing? If you are not sure, see
When to Use Ribbon on page 24.
14. Rotate the printhead-open lever downward until it locks the printhead in place.
If using… Then…
Direct Thermal media (no ribbon needed) Continue with step 14.
Thermal Transfer media (ribbon needed)
a. If you have not already done so,
load ribbon in the printer. See
Load the Ribbon on page 58.
b. Continue with step 14.
To Next Page
Loading...