57
Printer Setup and Operation
Load the Media—Cutter Mode or Delayed Cut Mode
5/22/17 ZT600 Series™ User Guide P1088680-001
9. Close the media door.
10. Set the printer to the appropriate print mode (for more information, see PRINT MODE
on page 111).
11. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
12. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 192.
13. If desired, print a configuration or other label to verify that your printer is able to print.
(See PRINT INFORMATION on page 120.)
Media loading in Cutter mode is complete.
To Next Page
Loading...